Following in Dads Footsteps

Susan Robinson
July 10, 2018

spacer

Another great Aussie die ‘Farmer and Boy’ 17511 from Paper Rose Studio.

I created the background by swiping Oregano alcohol ink over Yupo paper with a thin cotton square. Working quickly I held the paper on its side, then ran Stream, Meadow, Caramel and Rust inks in streams down it. Keep adding from both sides until the paper is completely covered. It will dry by itself very quickly.

I poured a few drops of Alcohol Blending Solution into a bottle cap, picked up with a paintbrush and applied dots over card to create patterns. I then did the same with glue pen. Set aside. When dry, lay gold Fab Foil sheet over glue dots, press down with finger tips, then lift off. The gold colour will adhere to the glue dots.

Cut out complete die in black card. Cut out boy only a 2nd time. Rub silver, gold and copper Rub-Ons over boy using fingertips to colour. Magic Mount in place. Matt finished card onto layer of black then rust card, before adhering to green folded backing card.

Stamp wording onto rust card, matt onto black, then Magic Mount onto top right of card.

spacer

Father’s Lighthouse

admin
August 28, 2015

spacer

Father's Lighthouse “A Father is neither an anchor to hold us back nor a sail to take us there, but a guiding light whose love shows us the way”. Happy Father’s Day card for my dear old Dad. I actually thought it was this Sunday, so I’m way ahead of the game for a change.

“Father Guides” 3820E by Stamp-it

I wet the watercolour paper, then coloured the bottom half with ink sprays (Dylusion: Dirty Martini & Calypso Teal; Distress: Evergreen Bough), then while still wet, ran the dropper from Distress re-inker bottles Spiced Marmalade & Walnut Stain across middle. Set aside to dry. I stamped the lighthouse onto clear film with black StazOn pad, stamped it again onto scrap of white card, which I coloured in and cut out to lay over image on film. I stamped the waves onto scrap of mulberry paper which I tore along bottom and glued at base of lighthouse. I used glossy accents over the glass top of lighthouse. Then because I had used clear film, but didn’t want to spoil the look with split pins in each corner to attach the layers, I had to cut a frame out and mount over to cover up my 2-sided foam tape. Attached the complete frame then onto teal backing card.

 

20150828_195445

spacer